 |
Easy Installation. - Simply install the BackOFF-MC module in line with your brake light wire between your brake light switch and your brake light.
Large power capacity: - 12 volts DC, Maximum Capacity 10 Amps!
Sealed Weather Resistant heak sink case. Limited Warranty - One Year! 
PLEASE NOTE: This module may not work on bikes that use L.E.D. lighting! However, the BackOFF-XP works with all types of lights.
Maximize your Brake Light Effectiveness with BackOFF. This compact solid state electronic module converts your ordinary brake light into an attention getting visual alerting device, creating more visibility and conspicuity when you are stopped or stopping. With BackOFF installed, when you apply your brakes, it causes your brake light to automatically emit a visual alerting signal of 3 short light flashes, followed by 1 steady on light condition of 3.5 seconds. This signal automatically repeats itself as long as the brakes are applied. This pattern is not random, but has been selected because of its ability to gain and retain following drivers attention.
Most states drivers handbooks recommend that you flash your brakes when slowing or stopping. The BackOFF automatically facilitates compliance and enhances safety. Install the BackOFF and see how much more effective your brake light can be.
Compact size. - 2-1/4"L x 1-5/8"W x 5/8"H and can be mounted easily with included double sided tape!
FLASHING PATTERN:
This module will cause your brake lights to quickly flash 3 times, and then go steady on for 3-4 seconds, and repeat.
NOTE: This module is rated at 10 Amps which will only drive 3 - 1156/1157 bulbs. If you have a vehicle with more than three brake lights we recommend only modulating two of these bulbs, it will be plenty attention getting enough and give you redundancy in case of some kind of failure. Please DO NOT install any BackOFF Brake Light product on your turn signals, it is illegal and also confusing to following vehicles.
OTHER BACKOFF PRODUCTS AVAILABLE:
|
|
|
|
|
|
For motorcycles with any type of brake light bulb! LED's or incandescents will work with this module. With the same flash pattern of the ORIGINAL BackOFF this module is worth the extra few dollars is you have or plan to have LED's on your motorcycle. only $42.95 |
The Brake Hold module connects to your bikes electronic speed sensor to keep your brake lights on while you're stopped or stopping. Even when you remove your hands and feet from the brakes as you're downshifting for just decelerating, your brakes will still be illuminated to following vehicles. only $64.95 |
Customer Reviews:
kerrypierce@comcast.net (Tuesday, 12 October 2010)Rating:
Great product. Easy to install and it works as advertised. I'm very pleased with it.