Wiring your bike just got easyä
| Step 1: Mount the rear module in the rear of the bike, connect the harness to the module, and run the color coded wires to the devices in the rear of the bike. |  |
| Step 2: Mount the front module under the tank or in the headlight housing, connect the harness, and run the color coded wires to the devices in the front of the bike. Plug the two harness together. (Note: Only 4 wires between the modules, that is all that runs up the backbone!) |  |
| Step 3: Drill holes in the handlebars for the left and right switches and run the wires from each switch to the hole where the display module will be mounted. |  |
| Step 4: Plug in the cables into the switches, and mount them with the saddle clamp switch housings. (Note: The ends can be cut off the wire, and easily re-crimped if needed) |  |
| Step 5: Plug the wire from the front module, and the two wires from each switch into the display module. The ends can be cut off the wire, and easily re-crimped if needed. |  |
| Step 6: Mount the display housing to the handlebar clamps (clamps not included) |  |
|
|
