Tri-Star Modulator![]()
![]()
![]()
![]()
![]()
![]()
![]()
Installation Instructions
Cut the two positive wires powering your rear turn signals in two and splice Tri-Star in-line as pictured to the right.
Connect the module to ground and a 12V power supply as pictured below.
Splice the red/black wire into a brake light source (this wire should only be energized when the brakes are applied.
Circuit Protection: It is highly recommended that the turn signal circuit be protected with a 10 amp fuse or circuit breaker in the power supply lead (orange wire).
Circuit Layout: The adjacent wire code and schematic is typical for most installation. Use appropriate gauge wire.
Mounting: It is recommended that the module be mounted in a location not subject to extreme heat conditions. It can be mounted with the included double sided adhesive tape or any other suitable means.

Many turn signal systems require the load current provided by the rear turn signal lamps to flash properly. If your turn signals do not work after following the following the above instructions, then add the Dual Load Equalizer as shown in the diagram below. The Dual Load Equalizer provides the current required to make the turn signals flash. Do not connect a Dual Load Equalizer to the Tri-Star Module outputs (White-Violet or White-Brown) as it is not needed, wastes power and serves no purpose as the Tri-Star has no output current requirements to work properly.
